Jump to content

Recommended Posts

Hi,

 

I am about installing my simulator step by step (changing from FSX to P3D V 4.2) on a new Server PC.

 

Just installed the EFB and got the message, that there is EFB still installed on the old Server PC. This PC will either not be used for FS purposes or (have not made up my mind finally) as Client PC, replacing the present client with the "old" EFB displa unit.

 

What are the propper steps that I will not have a licence key conflict ? 

 

Best regards 

Bernd

Share this post


Link to post
Share on other sites

Hi Bernd,

Quote

Just installed the EFB and got the message, that there is EFB still installed on the old Server PC

I don't know this message. Can you provide a screenshot? Thanks.

Share this post


Link to post
Share on other sites

Hi Urs,

the message showed up just for a short moment and disappeared. So I do not have a screenshot, unless I would properly delete the EFB and install again (?). As far as I remeber it was telling that there is a second installation on a second PC and I should check the licenze agreement ? But I am not sure.
If this was the message, would it mean, that I have to delete the EFB on the old PC, although it stays in my privat network and will not be used for FS activities ?

Regards

Bernd

Share this post


Link to post
Share on other sites

Hi Bernd,

I have reset your license to allow further installation. Now the message will no longer appear.

Share this post


Link to post
Share on other sites

×