cubpilot Posted June 12, 2016 Share Posted June 12, 2016 I have just reinstalled after a hard disk failure. EFB has been working perfectly for years. The FSX pc is the same although I now have only FSX-Steam installed. The Data Provider loads as it should, all folders are correct and It is ready for connection (See attached efblog) The display unit is on a networked laptop and is configured for the network. The only problem that I know of is that it will not accept ADD an Aircraft in the MISC section, the keyboard will not type in the block. According to the log there is some kind of interrupt (please see attch. DisplayLog) I am at a complete loss after three hours of trying to get it going. Btw...I reinstalled 2.5.7 and had the same error Then updated to 2.5.8 Problem not solved I turned off Anti-Virus, set both Data and Display to run as ADMIN Help please Neal Howard efblog.txt DisplayLog.txt 0 Link to comment Share on other sites More sharing options...
cubpilot Posted June 13, 2016 Author Share Posted June 13, 2016 I have tracked the source of the error but know nothing about fixing it. Please read the attached file. EFB Error.txt I could really use some help here. EFB is the best tool I have for FSX Neal Howard Link to comment Share on other sites More sharing options...
aivlasoft Posted June 13, 2016 Share Posted June 13, 2016 Hi Neal, can you send me the complete logfiles from both the DataProvider and DisplayUnit to support@aivlasoft.com? can you also send the settings file from both? Thanks. Link to comment Share on other sites More sharing options...
RonnieDuck Posted June 29, 2016 Share Posted June 29, 2016 Hello I am having the same problems!! Is there an solution for you cubpilot / Neal? Regards Ronald Link to comment Share on other sites More sharing options...
Recommended Posts