nax228 Posted December 20, 2016 Share Posted December 20, 2016 Hi Urs On EKCH (FlyTampa) I have always noticed that taxiway E1, leading to holding point RW 22R from BRAVO is not shown in EFB. Yesterday I found that there also was some mistakes on EGSS where I taxied between taxiways and hade makings on my EFB map that did not exist in the scenery (UKExtreme). Is your maps generated from the present AFCADS+AIRACs, so faults like this is actually error in AFCADs? Another thing... When a taxiway is missing ID, is this also due to missing data in AFCAD? See chart for EKCH Ground: http://aim.naviair.dk/AIM%20Documents/AIP%20Danmark/AIP%20PART%203%20-%20FLYVEPLADSER%20(AD)/AD%202%20AERODROMES/K%C3%B8benhavn%20Kastrup%20-%20EKCH/EK_AD_2_EKCH_ADC_en.pdf Link to comment Share on other sites More sharing options...
aivlasoft Posted December 21, 2016 Share Posted December 21, 2016 Hi Geir, Is your maps generated from the present AFCADS+AIRACs, so faults like this is actually error in AFCADs? Another thing... When a taxiway is missing ID, is this also due to missing data in AFCAD? Yes, correct. EFB can only show the content of the *.bgl files. Link to comment Share on other sites More sharing options...
nax228 Posted December 21, 2016 Author Share Posted December 21, 2016 Thanks This particular error has been in the scenery since initial release, but would be corrected today and new AFCAD uploaded to their Forum. I tried looking into it using ADE, but I need to start on something smaller i guess Link to comment Share on other sites More sharing options...
Recommended Posts