PeterB

Same here. Everything is working fine except for the message.

Guys, I downloaded and installed the 1.15 Flight Plan Handler with no problems. I kicked off my DisplayUnit, created a route, saved it to the correct directory, imported it in my Airbus 321 and.. no route. Only the only the ICAO codes appear. No airways or fixes. I'm probably missing something obvious. Ideas? Thanks!

Reading the manual is usually helpful. Found the solution, made changes, all is OK. Pete

Guys, Here's my set up. My fsx runs on pc#1. My data provider is on #1. Aivlasoft Display unit is on pc#2. I just signed up for Navigraph and bought the AivlaSoft EFB Ad On cycle 1209 and installed it on pc#1 as is the Data Provider. I fired everything up and see that the data provider recognized AIRAC cycle 209. I created a flight plan EGKK EGCC. I tried to select an approach at EGCC and there are none as it was before I bought Navigraph. I know there are lots of approaches at EGCC. I know I'm doing something wrong or don't really understand how this is supposed to work. Should the display unit show all of the approaches at EGCC as provided by Navigraph? Thanks! Pete

Hi, Sometimes I can't get the Moving Map function to, well, move. The airplane icon is greyed out. I found that if I close the data provider and EFB the moving map function will work. Sometimes i have to close and restart everything more than once. Should you start FSX before EFB or EFB before FSX? Am doing something wrong? Thanks!

Hello, I have had the EFB and love it. This is the best add on I have made to FSX. Problem. I just started doing all of my flying on VATSIM. I changed the config for EFB to access the VATSIM files. Everything works great except clicking on the frequency does not give you the ability to send the frequency to COM1, COM2 active or standby. The selections are greyed out. I made sure I was connected to VATSIM and at a field that had active controllers. I must be doing something wrong. I really like this ability. Thanks! Pete