N1G

Hi Urs, thank you. I did find the ILS info on the chart but was hoping that these frequencies could be tied in on one of the tabs along with comm frequencies? I had the a/c visible at one time on the chart but for some reason could not get it to display. All connections to FSX box are good including ASE. I guess I will read a little more! Thanks again for your help it is much appreciated! Regards Bob

Hello, Just getting my feet wet but I was wondering where I can see the ILS frequencies of the arrival airport. I looked everywhere but I could not find them. Also, I created a short flight for testing and could not see my aircraft on the map. There was an icon in the bar below but it was disabled. Not sure what I am doing wrong. Regards Robert Ginn

Hi, Well, I am just a little hesitant to install 4.0 since I have no feedback. What was the primary reason for the 4.0 release? enhancements, bug fixes or both? I just worry a little about compatibility and with 3.5 I have had no issues at this time. So one could say "if it aint broke....." I will do a little reading today and try to get some answeres. Thanks for you input!!!! Regards Bob

Wyclife, thanks for the heads up. FSX is Win 7, Client is XP SP3 (DataDisplay). Do you recommend .net4 for each of these OS's? What is Aerosoft doing wrong? Regards Bob

Found the issue. I did not for some reason have .Net 3.5 installed. Not sure how this was skipped in installs but my guess is it was my fault Bob

Hi, Install went fine. Upon execution the following error: *** The application failed to initialize properly (0x0000135). Click on OK to terminate the application. ***** Uninstalled and reinstalled with same result. Tried reinstall with 1.3.1 alone and again with the SP3. Both resulted in the same error. Win XP SP3 Thanks Bob Ginn

Hi, Yes I did push the New button but the field did not allow characters. I reloaded this morning and it worked!!! Thanks for the reply. Regards Bob

Hi, Trying the Demo - Thank you for that opportunity! Dataprovider installed on Win7, Display Unit installed ib XP Dataprovider running & connected to FSX. Load Display Unit....... 1. remote machine Located. 2. Folder data and locations have been set 3. States I must select an aircraft. No aircraft in list. Create new aircraft disallows me to enter anything in the field. Although the settings were made on all the previous tabs and Ok button pushed, the program moves you to those tabs/fields which require a mandatory entry. Because it will not let me create an aircraft, I must close the application and all data entered previously in the other tabs is lost. Help Regards Bob