I wonder if you can advise what is the problem here.... I think it's the A320 radio at fault but can you confirm ?
This is a post I made to the developer....
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
QUOTE :-
I had the misfortune, while on the ' Vatsim new Codec stress test Event ' recently when I was calling the controller on the wrong channel, he was very busy and there were a lot of pilots on frequency. It was embarrassing.
I had entered the last controller's handoff COM frequency into the Aivlasoft numeric input panel as shown... but the last digit was changed to a '0' instead of a '5'
For example - 119.875 was changed to 119.870 in the aircraft radio.
I think you have to make the frequency steps in 8.33 Khz spacing.
I believe 8.33 Khz spacing is now adopted by the industry and Vatsim uses this channel spacing, mimicking real world.
It was hard to understand what had happened at first then to try and resync the aircraft radio.
Are there any plans regarding this ?
PS- Maybe it's when the calculations are rounding up... maybe if you calculate to 4 decimal places and only display the 3 decimal places .
Just had a thought... if the freq now has an extra 2 decimal places (8.33 Khz) then a full freq could look like 119.87533 Mhz maybe, therefore you should calculate to 5 decimal places or 6 ?
EDIT:-
Simconnect shows capability for 6 decimal places...
