Jump to content

Cycle 2002: CYUL missing ILS & RNAV for RWY 06L


viperxbr

Recommended Posts

Hi Todd,

 

It is neither a Navigraph nor NavDataPro problem but a Flight Simulator problem 😀. The problem can be identified by pressing the Ctrl+Alt+A combo. It shows a mismatch between the THR 06L used on the ground layout and the one used in the AIRAC data. In this case the difference is just above the "trigger distance" of 1000 m. Therefore EFB2 cannot assign any procedure for RWY 06L. (see also missing DEP procedure). I'm not sure when this THR displacement was issued. According to the official ground chart is it now active. I'm also not sure whether this is a temporary shortening or not. in any case, using the correct THR position brings the procedures  back on RWY 06L. See screenshot.

 

CYUL_06L.png.0360779b26a62383f9c94a902096e04b.png

 

As a temporary solution you can use one of the the attached BGL in the AFCAD folder of your EFB2 installation. Be sure to re-run the DBBuilder therafter. We will publish and amend these BGLs also in the Contributions AFCAD section. In case you have already used a CYUL AFCAD file, delete the old one and replace it with one of the new ones.

 

For Default CYUL:

CYUL.zip

 

For FlyTampa CYUL:

CYUL_FT.zip

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...