Jump to content

Recommended Posts

As with the release of Prepar3D v4.2 some technical requirements with SimConnect have been changed by LM. Therefore the previous version 1.0.13 of SimpleCam does no longer work with Prepar3D v4.2 ff.  For Prepar3D v4.2 ff a new version 1.1.14 has been released.


However, version 1.0.13 still works with FSX, FSX:SE, Prepar3D v2, Prepar3D v3, Prepar3D v4 - v4.1.


Important (1):
Both versions of SimpleCam, v1.0.13 and v1.1.14 can be installed side by side. However, this is only necessary if you have a mixed installation of the above listed simulators (e.g. FSX:SE and P3D v4.2, or P3D v3 and P3D v4.2).


Important (2):
If you upgrade from 1.0.13 to 1.1.14 and you no longer need the previous version 1.0.13, you can uninstall 1.0.13 before you run the installer for version 1.1.14.


If you uninstall the previous version but you would like to keep your program settings to be used with the new version, you may copy/paste the settings file to a save location and then, after the new version 1.1.14 has been successfully installed, copy/paste it back to the origin location. The settings file is located as follows: "C:\Users\<username>\Documents\AivlaSoft\SimpleCam\Settings.txt".


If you want to keep the camera settings for your aircraft, then you have to confirm the 1.0.13 uninstaller's question "Would you like to keep the aircraft specific camera settings?".


Link to post
Share on other sites
This topic is now closed to further replies.
  • Create New...