perry.vlachos Posted October 30, 2017 Share Posted October 30, 2017 I cannot see any traffic at all either on the airport or during the flight, I have already made the clicks at the relevant fields on the setup, what am I doing wrong Thank you Pericles Link to comment Share on other sites More sharing options...
conradcollinson Posted October 30, 2017 Share Posted October 30, 2017 6 hours ago, perry.vlachos said: I cannot see any traffic at all either on the airport or during the flight, I have already made the clicks at the relevant fields on the setup, what am I doing wrong Thank you Pericles If you could post a screenshot of you traffic setting that would be a great help. EFB Display Unit > System > Settings > Charts > Traffic Link to comment Share on other sites More sharing options...
perry.vlachos Posted November 7, 2017 Author Share Posted November 7, 2017 I am sorry for the delay to send the screenshot Link to comment Share on other sites More sharing options...
aivlasoft Posted November 7, 2017 Share Posted November 7, 2017 Looks good so far. Please have a look into the manual, section 7, page 19: Did you also select the TRFC option? Link to comment Share on other sites More sharing options...
perry.vlachos Posted November 7, 2017 Author Share Posted November 7, 2017 I read the page on manual can you explain me this paragraph As a prerequisite for the depiction of other aircraft on the charts, the corresponding settings in FS must be set. If no AI traffic is generated by FS you wont see all these aircraft symbols on the chart. where are those settings you mean this, see attachment Link to comment Share on other sites More sharing options...
aivlasoft Posted November 7, 2017 Share Posted November 7, 2017 These are the settings! Maybe you should try to decrease the amount of traffic by moving the sliders to the left. SimConnect is well known that too much traffic will not be forwarded to a listening program like EFB. Link to comment Share on other sites More sharing options...
perry.vlachos Posted November 7, 2017 Author Share Posted November 7, 2017 I will check this as soon as I reopen my FSX PC should I stop SimConnect? Thank you for your help Link to comment Share on other sites More sharing options...
aivlasoft Posted November 7, 2017 Share Posted November 7, 2017 You can't stop SimConnect. SimConnect is the programming interface between EFB and FSX. There is no manual access to it. Just reduce the amount of AI traffic, then restart your computer and try again. Link to comment Share on other sites More sharing options...
perry.vlachos Posted November 7, 2017 Author Share Posted November 7, 2017 ok thank you again Link to comment Share on other sites More sharing options...
Recommended Posts