Eisbahn

Urs, Thanks for the rapid response. Terry

Hello All, I have the following problem. When I create a flight plan everything functions as expected except for the departure procedure. All runways and SID procedures are displayed in the Departure window but the Set FPL button is never available. It is always blacked out. As you can see from the screen shot the procedure is displayed as expected on the map. The resulting saved flight plan has everything apart from the departure procedure. Any help would be appreciated.

Hi Urs, I already tried that with the .txt postfix. I received exactly the same message. I will send it by email. Terry

Hallo Urs, I'm afraid this is not the problem. My flight plan was created in EFB itself. However, after saving I cannot reload it into EFB. I have attached the fault message and log files. I cannot upload the flight plan because I receive the following: "The upload was rejected because the uploaded file was identified as a possible attack vector". Thanks for your help. Terry DataProvider_log.txt DisplayUnit_log.txt

Hi, Since upgrading to Version 1.5 I have the following problem: Creating a flight plan works perfectly. I then save the file as a normal FSX flight plan (.pln). However, when I try to reload the plan I receive the error message "Unhandled exception ..... Object reference not set to an instance of an object" The flight plan still works correctly in FSX and Prepar3D. Any help appreciated. Terry

Open your eyes. His real name is Travis. Terry

Hi Urs, Sorry about the name. I forgot about it. Thanks for the reply. Everything is now working fine. Terry

Hi Urs, I have been using EFB for a long time with the display unit being on both the same PC as FSX, and also on a networked PC. I recently had a BSD on the PC running both the provider and display units. Since then I get the following fault message when I start the Display Unit. The Display Unit on the networked PC functions normally. I have tried a complete re-install without success.

Hallo, I can confirm that if you follow the instructions from Urs, i.e run the full installation package 1.3.1 and then run SP4, everything will function correctly. I did it myself last week. Terry

Hi Urs, I deleted the files and everything is now working again. Thanks for your help. Terry

Hi Urs, Thanks for your promt reply. I have had SP4 installed for both units since it was introduced. Everything was working fine until this morning. When I received the first warning message I re-installed both the DP and DU. I have now deleted the file FormSettings.bin and re-installed both again. However everything is still the same. Is this the correct file? If not which settings file do I have to delete? Terry

Hallo I have recently experienced the following fault with the Display Unit on the same PC as the Data Provider: When I attempt to start the Display Unit I receive the enclosed fault message. The Display Unit on my second PC, over the network, functions normally. Any help appreciated. Terry

This problem is discussed many times on the Internet. Try this site for possible solutions. http://www.techspot.com/vb/topic105844.html Good luck. Terry

This has now been resolved. The new router had installed a different firewall programme. After this was removed everything returned to normal. Terry

Hallo All I now have a new Internet provider and also a new router. However, when I try to connect the remote Display Unit to the Data Provider, over my network, I receive the following fault message: Socket Exception: The requested name is valid, but no data of the requested type was found. I also receive the message when I activate the button for checking the server name. Nothing has changed, other than the new router. I have checked all the settings, including the name of the server, and everything seems correct. The local Display Unit functions normally. I have also checked that the Display Unit is not being blocked by the firewall. Any help would be appreciated. Terry