[Problem with default navaid in P3D v4.5]

16 minutes ago, lonewulf47 said:

Yes, the default scenery is wrong. EFB checks the data integrity vs. real world data (Navigraph Airac Cycle in your case). If a certain position error is exceeded, the Navaid will not be displayed.

Ok. Thanks for your quick support. Have a nice evening.
Ciao
Renato

 

[Problem with default navaid in P3D v4.5]

18 hours ago, lonewulf47 said:

I suspect a complete mismatch of the default coordinates vs. real world.

 

LOC 27 ISF:   42.697810 23.376482 default -> approx. 1300m too far west

                       42.697944 23.392250 real world

LOC 09 ISL:   42.694108 23.433722 default -> approx. 780m too far west

                       42.694888 23.443305 real world

Hi,

so the problem could be a mismatch of the default scenery in P3D ?

Renato

 

[Problem with default navaid in P3D v4.5]

Hi Urs,

 

the airacs is the last Navigraph cycle 2101 rev.1

 

Bye

Renato

[Problem with default navaid in P3D v4.5]

Hi,

i am facing a strange problem on the default scenery of Sofia ( LBSF ) airport ( Prepar3d v4.5).

When i try to select the arrival procedure on rwy 27, no proc are available, while the runway is equipped with two ILS proc ( Y and Z ). With the ADE editor i was scanning the scenery and everything seem good. 

I did another check with LittleNav Map software and both ILS for Rwy 09 and 27 are on the map.

The scenery is working properly, because i am able to intercept LOC and GLIDE on the right frequency. The problem is not on my simulator, but seen on sim of friends of mine.

Server and display are Ver 2.2 build #123.

 

Enclosed 3 picture just to help you to investigate.

Waiting for your response.

Thanks and regards.

Renato 

 

[LIMF localizer]

Thanks for the answer. Meanwhile i found the problem : a wrong setting of magnetic declination in the ADE project was the cause of the problem.

Thanks anyway.

Renato

 

[LIMF localizer]

Good afternoon all.

I have a strange problem on Torino airport ( Icao LIMF ). In the enclosed picture the localizer course in correct in the map ( 002° ) but is wrong in the vertical profile map. The course near the localizer frequency is 000° instead of 002°.

This is a custom scenery, but in Prepar3d ( V4.5 ) the frequency and course are correct.

Any idea ?

Thanks and regards.

 

Renato G.